Upgrading from ICD Pro

[chronicthehedgehog]

Hi,

I was previously using ICD drivers with 6 x 512mb BGM partitions on one device and 6 x 32Mb FAT16 (type 4) partitions on another.

I've installed HDDRIVER to C: but I can only see drives C/D/E on the first device when using TOS 2.06. All partitions are still visible from EmuTOS.

This is real hardware.

The manual implies that some partition conversion is required. Is there a tool or do I need to do something else?

Thanks

[uweseimet]

Hi,

This is very likely because the ICD software (at least old versions, maybe newer versions have an option to control this) does not create an AHDI compatible partition layout when you have more than 3 partitions on a drive. Also see "Do I lose any data when switching to HDDRIVER from another driver?" in the HDDRIVER FAQ.

[chronicthehedgehog]

OK thanks. I think I'll just partition another SD card and copy data over

[uweseimet]

If you can do that this is even better than using the ICD2AHDI tool, because when using such a tool a backup is recommended, which you do not need if you can copy the data instead.